Friday, January 29, 2010

What Size Trowel Do You Use For Ceramic Tile On A Wall Which Size Trowel Is Best For 4x4 Tile?

Which size trowel is best for 4x4 tile? - what size trowel do you use for ceramic tile on a wall

I install 4x4 tiles on a shower wall. I have a 1 / 4 x 1 / 4 foot area of the first class, but I remain problems with the frames ... I use a 3 / 16 x 5 / 32 V-shaped notch trowel instead?

5 comments:

JeffeVer... said...

Mike and Rob are correct - 1 / 4 "square notch a 4x4 tiles. A 4x4 tile is relatively small when you are touching it, there is a problem with his technique.

You need a modified thinset (before non-mixed use (the material in a bath) thinset "" - is actually a water-based glue and not be passed in wetlands), consistencey mixed with peanut butter. A common mistake is to mix your mortar too wet craftsmen.

First, the thinset to the wall with the right edge of the trowel and her work and apply several times. This key in the mortar joint Backer (Backer Cement Board implemented, right?) For a good adhesion to the wall. Then, with the serrated knife in a constant 45-degree angle to the walls obtained for excess mortar. And the Work in small sections - with 4x4 tile, apply the thinset into 2 "squares - if that is not thinset (and handle) in bulk, before creating all the chips in place. Small mixing thinset too. Check the label, butthinset more time for the "pot 1-2 hours (as long as you can on the cube before it is headquartered) remain to be - bigger than the will and the mortar is loose and stick composition tables do not.

You can start to simplify the installation of wall tiles to screw a board on the wall (or 1x2 strip of wood is good), 3-4 courses from the ground. This contributes to their first course, and tile spacers support successive courses. Then remove the plate and fill in the courses of substance.

Mike H said...

are clearly on the packaging of cement / mortar was not disclosed. but usually 1 / 4 X 1 / 4, full coverage and press firmaly. If you have the stone in place as close as possible to the desired location and give little to align the tiles, press firmly for a few seconds and release. if it is not something that is not going about your question.

rob s said...

Sorry guys wrong. You need a place 1 / 4 using x 1 / 4 notched trowel. You do not have sufficient coverage in av notch trowel. These brackets are to be filled for an area (not wet) and mosaics ..

Your all morons said...

If I use a palette I use a V-notched trowel adhesive spreasding in "8" configuration of the walls, I use a palette with 5/16th 's groove.

marvin A said...

Tiles on the wall in the small V-shaped notch is the best.
before the tiles - just clean the back of each with some of the tail --- whom GLOP up - only wet.

Post a Comment